Patton electronic SmartNode 4110 Series manual Enabling ‘early-proceeding’ on H.323 interfaces

SmartWare Software Configuration Guide 38 • H.323 interface configuration

Mode: Interface H.323

Step

1

Command	Purpose
node(if- h323)[if-name]#clip-clir-support	Enables CLIP/CLIR support on the H.323
	interface

Example: Enable CLIP/CLIR support

The following example shows how to enable CLIP/CLIR support on the H.323 interface MyH323If.

node>enable

node#configure node(cfg)#context cs

node(ctx-cs)[switch]#interface h323 MyH323If node(if-h323)[MyH323If]#clip-clir-support

Enabling ‘early-proceeding’ on H.323 interfaces

The early-proceedingcommand can enable the early-proceeding feature on H.323. If this feature is enabled, the gateway will immediately reply with an H.225 (H.323) call-proceeding message in response to a received H.225 (H.323) setup message without waiting for a response from the destination.

Mode: interface h323 <if-h323>

Step

1

Command	Purpose
[name](if-h323)[if-name]#early-proceeding	Enables the early-proceeding feature.

Example: Enable early call disconnect

The following example shows how to enable early call disconnect on an H.323 interface named MyH323If.

node>enable

node#configure node(cfg)#context cs

node(ctx-cs)[switch]#interface h323 MyH323If node(if-h323)[MyH323If]#early-disconnect

Enabling the early call connect (optional)

The early-connectcommand can be enabled to open a data path before the call is connected to play inband information from the ISDN side.

Mode: interface h323

Step

1

Command	Purpose
[name](if-h323)[name]#early-connect	Enables the early-connect feature.

H.323 interface configuration task list 436