Patton electronic SmartNode 4110 Series manual Serial port configuration

SmartWare Software Configuration Guide Table of Contents

Quick references	155
Setting the modem rate	155
Command cross reference	156
Link scheduler configuration task list	156
Defining the access control list profile	157
Packet classification	157
Creating an access control list	158
Creating a service policy profile	159
Specifying the handling of traffic-classes	161
Defining fair queuing weight	161
Defining the bit-rate	162
Defining absolute priority	162
Defining the maximum queue length	162
Specifying the type-of-service (TOS) field	162
Specifying the precedence field	163
Specifying differentiated services codepoint (DSCP) marking	163
Specifying layer 2 marking	164
Defining random early detection	165
Discarding Excess Load	165
Quality of Service for routed RTP streams	165
Devoting the service policy profile to an interface	167
Displaying link arbitration status	168
Displaying link scheduling profile information	168
Enable statistics gathering	168
14 Serial port configuration	170
Introduction	171
Serial port configuration task list	171
Disabling an interface	171
Enabling an interface	172
Configuring the serial encapsulation type	173
Configuring the hardware port protocol	173
Configuring the active clock edge	174
Configuring the baudrate	175
15 Frame Relay configuration	177
Introduction	178
Frame Relay configuration task list	178
Configuring Frame Relay encapsulation	178
Configuring the LMI type	179
Configuring the keep-alive interval	179
Enabling fragmentation	180
Entering Frame Relay PVC configuration mode	181
Configuring the PVC encapsulation type	182
Binding the Frame Relay PVC to IP interface	182
	10