Patton electronic SmartNode 4110 Series manual 109

SmartWare Software Configuration Guide 8 • RADIUS Client Configuration

The following procedure guides you through the steps necessary to enable RADIUS accounting in an existing configuration:

Mode: Configure

Step	Command	Purpose
1	node(cfg)# radius-client	Create a new RADIUS client
	<client-name>
2	node(radius)[client-name]#	Define the RADIUS server to be used. If the UDP port is omit-
	radius-server <server-	ted, the default port 1812 is used.
	name-or-ip> [<udp-port>]	Note For accounting RADIUS servers often use
		port 1813)
		Note There might also be RADIUS servers, which still
		use the old RADIUS ports 1645 or 1646)
3	node(radius)[client-name]#	Define the shared secret to access the RADIUS server
	shared-secret authentica-
	tion <secret>
4	node(radius)[client-name]#	Create an AAA profile, which uses the RADIUS client
	profile aaa <pf-name>
5	node(pf-auth)[pf-name]#	Define your newly created radius client as the AAA method
	method radius <radius-	to be used.
	client-name>	Note If you require redundancy, you can create multi-
		ple radius clients and add all of them to the
		AAA profile.
6	node(pf-auth)[pf-name]#	Switch to the circuit-switching context.
	context cs
7	node(ctx-cs)[ctx-name]#	Create an AAA call-control service
	service aaa <name>
8	node(svc-aaa)[svc-name]#	Define the newly created AAA profile to be used for account-
	accounting use profile	ing using this AAA service.
	<aaa-profile-name>
9	node(svc-aaa)[svc-name]#	Define the NAS-Identifier string to be included in RADIUS
	nas-identifier <nas-identi-	requests sent from this AAA service.
	fier>
10	node(svc-aaa)[svc-name]#	Optionally, you can also configure the AAA service to
(Optional)	authentication use profile	request authentication using the calls calling E.164 number.
	<aaa-profile-name>	If this is required, you can define the AAA profile used for
		authentication using this command.
11	node(svc-aaa)[svc-name]#	Define, if calls shall be dropped, if accounting fails. The
(Optional)	accounting-failure-action	default is to ignore accounting failures.
	[drop-calls ignore]

RADIUS configuration 109