SmartWare Software Configuration Guide

33 • CS interface configuration

 

 

page 529 and chapter 47, “VoIP profile configuration” on page 573. To create and configure CS interfaces you have to perform the configuration tasks listed below.

Creating and configuring CS interfaces

Configuring call routing

Configuring the interface mapping tables (optional)

Configuring the precall service tables (optional)

Configuring interface type specific parameters

Creating and configuring CS interfaces

To configure CS interfaces, you must first enter the CS context mode where you can create and configure your required interface through the CS interface configuration mode. Each interface has a name that can be any arbitrary string of not more than 25 characters. Use a name describing the purpose of the interface, as shown in the examples or—for ease of identification—the interface type can be used as part of the name. Already- defined CS interfaces can be displayed or deleted as described in the following table.

Procedure: Create and configure CS interfaces.

Mode: Configure

Step

Command

Purpose

 

 

 

1

node(cfg)#context cs

Enter the CS Context Configuration Mode.

 

 

 

2

node(ctx-cs)[switch]#interface if-type if-

Enter the CS Interface Configuration Mode & select

 

name

the CS interface with type if-typeand name if-name

 

 

for configuration. Valid interface types are h323,

 

 

sip, isdn and fxs.

 

 

 

3

node(if-type)[if-name]#…

Perform the configuration tasks to configure the CS

 

 

interface.

 

 

 

4

node(ctx-cs)[switch]#show call-control

Display the configuration of the current CS interface.

 

provider

 

 

 

 

5

node(if-type)[if-name]#exit

Go back to the CS Context Configuration Mode

 

 

 

6

 

Repeat step 1 to 5 to create and configure your CS

 

 

interfaces

 

 

 

7

node(ctx-cs)[switch]#show call-control

Display already defined CS interfaces.

 

provider

Note: The show call-control provider command can

 

or

also be used to display the configuration details of a

 

node(ctx-cs)[switch]#show call-control

provider either by specifying its name as a parame-

 

status

ter or by being inside its configuration mode.

 

 

 

8

node(ctx-cs)[switch]#no interface if-type if-

Delete an existing interface.

 

name

 

 

 

 

Examples: Create CS interfaces and delete another

Creating and configuring CS interfaces

383

Page 383
Image 383
Patton electronic SmartNode 4110 Series manual Examples Create CS interfaces and delete another, Nodeif-typeif-name#…