Patton electronic SmartNode 4110 Series manual Structure of a Service-Policy Profile

SmartWare Software Configuration Guide				13 • Link scheduler configuration
profile service-policy <profile-name>
			link rate,	arbitration
	common settings
			common parameters
source traffic-class <x>
			bandwidth, packet mark
		settings for class x
			queue-size, etc.
source traffic-class <y>
		settings for class y
source traffic-class default
		settings for all other
		traffic-classes not listed

Figure 26. Structure of a Service-Policy Profile

The template shown above specifies an arbiter with three inputs which we call “sources”: x, y and “default”. The traffic-class “default” stands for all other packets that belong neither to traffic-class x nor y. There is no limit on the number of sources an arbiter can have.

Example: Creating a service policy profile

The following example shows how to create a top service-policy profile named sample. This profile does not include any hierarchical sub-profiles. The bandwidth of the outbound link is limited to 512 kbps therefore the interface rate-limit is set to 512. In addition weighted fair queuing (wfq) is used as arbitration scheme among the source classes.

profile service-policy sample rate-limit 512

mode wfq

source traffic-class local-voice priority

source traffic-class Web share 30

source traffic-class local-default share 20

source traffic-class default queue-limit 40

share 50

The first line specifies the name of the link arbiter profile to configure. On the second line the global band- width limit is set. The value defining the bandwidth is given in kilobits per second. Each service-policy profile must have a “rate-limit” except if no scheduling is used i.e. the link scheduler is used for packet marking only (like setting the TOS byte).

How the bandwidth on an IP interface is shared among the source classes is defined on the third line. The mode command allows selecting between the weighted fair queuing and shaping arbitration mode. The default mode is wfq - the command shown above can therefore be omitted.

Link scheduler configuration task list 160