Patton electronic SmartNode 4110 Series specification

SmartWare Software Configuration Guide	49 • SIP profile configuration

Introduction

The SIP proﬁle speciﬁes disconnect cause mappings from SIP codes to Q.931 causes, and vice versa. As for all proﬁles, there is a default proﬁle at system startup that can be modiﬁed. Only those causes that differ from the default mapping have to be conﬁgured. If a new proﬁle is created, all mappings are set to their default and are only overwritten if conﬁgured. The default mapping in both directions is according to RFC3398 - ISUP to SIP Mapping.

A SIP proﬁle can either be attached to SIP interfaces or to identities. To see how to conﬁgure a SIP proﬁle for an interface, see Chapter 39, “SIP interface conﬁguration” on page 441. For information about SIP proﬁle conﬁguration for identities, see Chapter 51, “Location Service” on page 607.

SIP proﬁle conﬁguration task list

This section describes the conﬁguration tasks for SIP proﬁle listed below.

•Enter the conﬁguration mode for a SIP proﬁle (see page 602)

•Map from a SIP disconnect cause to a Q.931 cause (see page 602)

•Map to a SIP cause from a Q.931 disconnect cause (see page 603)

•Map from a SIP redirection code to a Q.931 redirect reason (see page 603)

•Map to a SIP redirection code from a Q.931 redirect reason (see page 603)

Entering the conﬁguration mode for a SIP proﬁle

The proﬁle sip command enters the conﬁguration mode of an existing proﬁle or creates a new one with a spec- iﬁed name. It also destroys an existing proﬁle except the default, which always exists.

Mode: Conﬁgure

Step	Command	Purpose

1	[name](cfg)#[no] profile name <name>	Creates/Destroys a SIP profile or enter the con-
		figuration mode of an existing one.

Mapping from a SIP disconnect cause

The map cause from-sipcommand maps a speciﬁc SIP disconnect cause to a Q.931 cause used by the call con- trol. All causes are pre-deﬁned in the system and are provided by the command.

Mode: Proﬁle SIP

Step	Command	Purpose

1	[name](pf-sip)[name]#map cause from-	Maps a specific SIP disconnect cause to a
	sip sip-cause to q931-cause	Q.931 cause.

Introduction

602

Patton electronic SmartNode 4110 Series manual SIP proﬁle conﬁguration task list

Models: SmartNode 4110 Series

SmartWare Software Configuration Guide

Introduction

SIP proﬁle conﬁguration task list

Entering the conﬁguration mode for a SIP proﬁle

Step

[name](cfg)#[no] profile name <name>

figuration mode of an existing one.

Mapping from a SIP disconnect cause

Step

sip sip-cause to q931-cause