Patton electronic SmartNode 4110 Series manual Deleting an FXO interface, Nodeif-fxo name #

SmartWare Software Configuration Guide 36 • FXO interface configuration

Once you are in the Context CS mode, you can enter the FXO configuration mode with the next steps.

Step	Prompt & command	Purpose
5	node(ctx-cs)[switch]#interface fxo name	The “interface fxo” command creates the new
		interface name, which represents an FXO inter-
		face. This command also places you in the FXO
		interface configuration mode for the created inter-
		face.
6	node(if-fxo)[name]#	You are now in the FXO interface configuration
		mode. In this mode, you may configure the param-
		eters for the FXO interface name

Example: Create an FXO interface named PSTN-FALLBACK

The following commands would be used—in Context CS mode—to create an FXO interface named

PSTN-FALLBACK:

node(ctx-cs)[switch]#interface fxo PSTN-FALLBACK node(if-fxo)[PSTN-FA~]#

Deleting an FXO interface

Almost every configuration command has a no form. In general, use the no form to disable a feature or func- tion. Use the command without the no keyword to re-enable a disabled feature or to enable a feature that is disabled by default. The no form of the FXO interface deletes the interface.

Mode: Context CS.

Step	Prompt & command	Purpose
1	node>	Basic prompt in Operator Exec mode
2	node>enable	Enters Administration execution mode
	node#	The prompt in administration execution mode
3	node#configure	Enters the Configure configuration mode
	node(cfg)#	The prompt in the Configure configuration mode
4	node(cfg)#context cs	Enters the context “CS” for Circuit Switch
	node(ctx-cs)[switch]#	The prompt in the Context CS configuration
		mode
5	node(ctx-cs)[switch]#no interface fxo name	Deletes the existing interface name

Deleting an FXO interface 417