Patton electronic SmartNode 4110 Series Changing the default UDP port range for RTP and Rtcp

SmartWare Software Configuration Guide 22 • Basic IP routing configuration

The necessary routing-table entries for the scenario described are listed below.

node>enable

node#configure node(cfg)#context ip router

node(ctx-ip)[router]# route 10.1.5.10 255.255.255.255 172.16.40.2 node(ctx-ip)[router]# route 10.2.0.0 255.255.0.0 172.17.100.2 node>show ip route

Routes of IP context 'router':

Status codes: * valid, U up, H host, G Gateway, L local, D default

Destination Nexthop Protocol Metric Flags Used

---------------------------------------------------------------------

* 127.0.0.1/32		local	0	LHG	n/a
* 172.16.40.1/24		local	0	LHG	n/a
* 172.17.100.1/24		local	0	LHG	n/a
* 172.17.100.0/24	wan	local	1	UL	0
* 172.16.40.0/16	lan	local	1	UL	0
* 10.1.5.10/32	172.16.40.2	static	0	U	0
* 10.2.0.0/16	172.17.100.2	static	0	U	0

Changing the default UDP port range for RTP and RTCP

The UDP port range to be used for RTP streams can be configured using the following procedure:

Mode: context ip

Step	Command	Purpose
1	[name] (ctx-ip)[router]# rtp-port-range <start-port><end-port>	Define the UDP port range
		for RTP/RTCP streams.

Changing the default UDP port range for RTP and RTCP 241