Patton electronic SmartNode 4110 Series manual Burst tolerant shaping or wfq, Hierarchy

SmartWare Software Configuration Guide 13 • Link scheduler configuration

service that is only available for a limited bandwidth e.g. low delay. When connecting the SmartNode to a Diff- Serv network shaping might be a required operation.

Burst tolerant shaping or wfq

For weighted fair queuing and shaping there is a variation of the scheduler that allows to specify if a traffic class may temporarily receive a higher rate as long as the average stays below the limit. This burstiness measure allows the network to explicitly assign buffers to bursty sources.

When you use shaping on the access link the shaper sometimes has the problem that multiple sources are scheduled for the same time - and therefore some of them will be served too late. If the rate of every source had to strictly obey its limit, all following packets would also have to be delayed by the same amount, and further collisions would reduce the achieved rate even further. To avoid this effect, the SmartWare shaper assumes that the burstiness needed for sources to catch up after collisions is implicitly allowed. Future versions of SmartWare might allow setting the burst rate and bursting size if more control over its behavior is considered necessary.

Burst tolerance has a different effect when used with weighted fair queuing. Think of it as a higher initial rate when a source device starts transmitting data packets. This allows giving a higher weight to short data transfers. This feature is sometimes referred to as a service curve.

Hierarchy

An arbiter can either use wfq or shaping to determine which source to serve next. If you want the scheduler to follow a combination of decision criteria you can combine different schedulers in hierarchy to do a multi-level arbitration.Hierarchical scheduling is supported in SmartWare with service-policy profiles used inside service- policy profiles.In figure 23 an example of hierarchical scheduling is illustrated. The 1st level arbiter Level_1 uses weighted fair queuing to share the bandwidth among source classes VPN, Web and incorporates the traffic from the 2nd level arbiter Low_Priority, which itself uses shaping to share the bandwidth among source classes Mail and Default.

Introduction 154