Patton electronic SmartNode 4110 Series manual 188

SmartWare Software Configuration Guide 15 • Frame Relay configuration

Figure 30. IP Context with logical IP interfaces bound to Ethernet port, serial port PVC 1 and PVC 2

The related IP, serial interface and Frame Relay configuration procedure is listed below. Where necessary, com- ments are added to the configuration for better understanding.

1.Enter the configuration mode.

node>enable

node#configure

…

2.Set up the IP interface configuration first. Be aware that not all of the necessary settings are listed below.

node(cfg)#context ip router node(ctx-ip)[router]#interface external node(if-ip)[external]#interface internal node(if-ip)[internal]#interface lan node(if-ip)[lan]#exit node(ctx-ip)[router]#interface internal node(if-ip)[internal]#ipaddress 192.168.3.1 255.255.255.0 node(if-ip)[internal]#interface external node(if-ip)[external]#ipaddress 192.168.2.1 255.255.255.0 node(if-ip)[external]#interface lan node(if-ip)[lan]#ipaddress 192.168.1.1 255.255.255.0

…

3.Define a voice profile which gives priority to voice packets. Set the rate limit according to the bandwidth available for voice and data on PVC 1 (512kBits/s in this case).

node(cfg)#profile service-policy VoicePrio node(pf-srvpl)[VoicePr~]#rate-limit 512 node(pf-srvpl)[VoicePr~]#source class local-voice node(src)[local-v~]#priority node(src)[local-v~]#source class local-default node(src)[local-d~]#priority node(src)[local-d~]#source class default

…

Frame Relay configuration task list 188