Patton electronic SmartNode 4110 Series manual Displaying configuration file information

SmartWare Software Configuration Guide 6 • Configuration file handling

Replacing the startup configuration with a configuration downloaded from TFTP server

From within the administration execution mode, you can replace the startup-configuration by downloading a configuration from the TFTP server into the flash memory area where to store the startup configuration.

Mode: Administrator execution

Step	Command	Purpose
1	node(cfg)# copy tftp://ip-address[:port]/	Downloads the configuration file new-startupfrom
	new-startupnvram:startup-config	the TFTP server at address ip-addressreplacing the
		existing persistent startup configuration. Optionally
		you can enter the UDP port where the TFTP server lis-
		tens. If the port is not specified, the default port 69 is
		used. This progress is visualized with a counter,
		counting up from 0 to 100% according to the down-
		loaded amount of the file size. Should the download
		fail, an error message % File Transfer - Get failed is
		displayed.

Example: Sample configuration download from the TFTP server

The following example shows how to replace the persistent startup configuration in the flash memory of a SmartNode by overwriting it with the configuration contained in the file new-startuplocated on the TFTP server at IP address 172.16.36.80.

1.Download the startup configuration with the copy command into the flash memory area where to store the startup configuration.

node>enable

node#configure

node(cfg)#copy tftp://172.16.36.80/user/new-startup nvram:startup-config Download...100%

node(cfg)#

2.Check the content of the persistent startup configuration by listing its command settings with the show command.

node#show nvram:startup-config

Displaying configuration file information

This procedure describes how to display information about configuration files

Mode: Administrator execution

Command	Purpose
show nvram:	Lists all persistent configurations
show running-config	Displays the contents of the running configuration file
show startup-config	Displays the contents of the startup configuration file

Configuration file handling task list 83