Patton electronic SmartNode 4110 Series manual Configure country specific FXO port parameters

SmartWare Software Configuration Guide 44 • FXO port configuration

Configure country specific FXO port parameters

Unlike ISDN, POTS is heavily country specific even though there is a good chance that a setting for one coun- try works reasonably good in another country. Country specific settings are contained in a so-called fxo profile which is integrated in the firmware of the SmartNode. It can be updated independently from the firmware by means of tftp download.

As there are over 190 countries SmartWare of course does not support all different country parameters. Thus before operation make sure that the country parameter for your country is available as profile.

Procedure: Configure country specific FXO parameters

Mode: Port FXO

Step	Command	Purpose
1	node(config)#port fxo slot port	Enter configuration mode for FXO port
2	node(prt-fxo)[slot/port]#use	Select a profile containing the country specific set-
	profile fxo profile	tings of the port. Available profiles are:
		• ‘etsi’ according to ETSI standard
		• ‘fcc68_25Hz’ for the United States of America /
		Canada, according to the FCC86 standard,
		with 25Hz ringing detection.
		• ‘fcc68_50Hz’ for the United States of America /
		Canada, according to the FCC86 standard,
		with 50Hz ringing detection.
		• ‘tbr21_25Hz’, according to the TBR 21 stan-
		dard, with 25Hz ringing detection.
		• ‘tbr21_50Hz’, according to the TBR 21 stan-
		dard, with 50Hz ringing detection.
		The default profile (not displayed in the list when
		entering the command) is etsi.

Other FXO port parameters

This section describes the commands available for the configuration of an FXO port.

Procedure: Configure the FXO port parameters

Configure country specific FXO port parameters 544