SmartWare Software Configuration Guide

12 • Ethernet port configuration

 

 

Mode: Configure

Step

Command

 

Purpose

 

 

 

1

node(config)#port ethernet slot port

Enter Ethernet port configura-

 

 

tion.

 

 

 

2

node(prt-eth)[slot/port]#vlan id

Create new VLAN port.

 

 

 

3

node(vlan)[id]#encapsulation {ippppoemulti}

Defines the payload type(s) to

 

 

be used on this VLAN:

 

 

ip: IP traffic only (not used

 

 

 

for PPP)

 

 

pppoe: PPPoE sessions only

 

 

multi: both IP traffic and

 

 

 

PPPoE sessions

 

 

For more information on the

 

 

PPP/PPPoE configuration see

 

 

chapter 30, “PPP configuration”

 

 

on page 313.

 

 

 

4

node(vlan)[id]#bind interface name [router]

Bind the VLAN port to the exist-

 

 

ing interface name. If no IP con-

 

 

text is given, the system attaches

 

 

the interface to the default IP

 

 

context known as router.

 

 

 

5

node(vlan)[id]#map cos layer-2-CoS-value to traffic-class-name

Selects the layer 2 CoS (Class of

 

 

Service) to traffic class map-

 

 

ping. The traffic class must

 

 

already exist.

 

 

 

6

node(vlan)[id]#no shutdown

Activate the VLAN port.

 

 

 

7

node(vlan)[id]#exit node(prt-eth)[slot/port]# no shutdown

Make sure the hosting Ethernet

 

 

port is also activated.

 

 

 

 

Configuring layer 2 CoS to service-class mapping for an Ethernet port

To enable to transport real-time and delay sensitive services such as VoIP traffic across the network, the firm- ware application software supports the delivery of Quality of Service (QoS) information in the ToS (Type of Service) field. This is an eight-bit field, the second field in the IP header packet. To define the Class of Service (CoS) to service class mapping, the cos command is used, with one of the following arguments:

default—Default service class when no Layer 2 CoS present

rx-map—Receive mapping table - Layer 2 CoS to service class mapping

tx-map—Transmit mapping table - Service class to Layer 2 CoS mapping This procedure describes how to change layer 2 CoS to service class mapping.

Ethernet port configuration task list

146

Page 146
Image 146
Patton electronic SmartNode 4110 Series manual Nodeconfig#port ethernet slot port, Nodeprt-ethslot/port#vlan id