Patton electronic SmartNode 4110 Series manual Adding a transmit mapping table entry

SmartWare Software Configuration Guide 12 • Ethernet port configuration

Adding a transmit mapping table entry

The transmit mapping table defines the conversion of transmitting firmware-specific service class value into a Layer 2 CoS to service class value. Each conversion is stored as a mapping table entry, so the transmitting map- ping table consists of several mapping table entries.

This procedure describes how to add a transmit mapping table entry.

Mode: Configure

Step	Command	Purpose
1	node(cfg)#port ethernet slot port	Enters Ethernet
		port configura-
		tion mode for
		the interface on
		slot and port.
2	node(prt-eth)[slot/port]#costx-mapservice class value as layer 2 class of	Adds a transmit
	service value	mapping table
		entry, which
		converts a ser-
		vice class value
		into a layer 2
		class of service.

Example: Adding a transmit mapping table entry

The following example shows how to add a transmit mapping table entry, which converts a service class value of 4 into a layer 2 class of service value of 2 for the Ethernet port on slot 0 and port 0.

node(cfg)#port ethernet 0 0 node(prt-eth)[0/0]#cos tx-map 4 as 2

Closing an Ethernet port

An Ethernet port can be closed with the shutdown command. This command also disables and closes the IP interface that is bound to that port. All static routing entries that are using this interface change their state to ‘invalid’ and all dynamic routing entries will be removed from the route table manager.

This command can be used as soon as an encapsulation type is defined and the port was bound successful to an IP interface.

This procedure describes how to disable the Ethernet port on slot and port.

Mode: Configure

Step Command Purpose

1node(cfg)#port ethernet slot port Enters Ethernet port configuration mode for the interface on slot and port

2node(prt-eth)[slot/port]#shutdownDisables Ethernet port on slot and port

The no prefix causes to open the port with the interface to which it is bound.

Ethernet port configuration task list 148