Patton electronic SmartNode 4110 Series Conferencing, Call park, Nameif-fxsname#no drop-passive

SmartWare Software Configuration Guide 35 • FXS interface configuration

Conferencing

When executing a conference, all involved calls will be handed to a given call-router conference service. It is then the responsibility of this service to initiate the conference. Conference services are configured in the Con- text CS and are protocol specific. The sip-conference service can be used to address a SIP Media Server for con- ferencing according to RFC4240 (see section, “SIP conference-service”on page 525).

Conferencing can only be executed if the second call was originated by the local subscriber. If the second call is an incoming call and the local subscriber tries to conference, the call toggle service will be executed.

Mode: Interface FXS

Step	Command	Purpose
1	[name](if-fxs)[name]#[no] route confer-	Specifies the routing destination for a conference.
	ence dest-service <service-name>	The no form of the command clears an existing
		route.

Call park

The call park service allows parking an ongoing call on a specific number. This park number starts with a spe- cific Park Code that must be configured with the 'service-pattern' command. After the user presses 'flash' to open a new call and the dialed number starts with the defined park service-pattern, the service will be executed five seconds after the last digit has been pressed or the user completes the number with the '#' character. This service is not handled locally, which means that another entity must be contacted that offers it.

On some SIP servers, it is possible to park a call on a specific number by using the blind-transfer feature. This is what the FXS park-call service achieves in an FXS/SIP call. It forces the SIP endpoint to execute a blind transfer where the Refer-To header contains the park number.

To change the park service pattern, the already existing 'service-pattern' command has the option 'park' that allows the user to overwrite the default setting.

Mode: Interface FXS

Step	Command	Purpose
1	[name](if-fxs)[name]#[no] {drop-passive	Defines a new key pattern for the selected service.
	drop-active toggle conference park}	The no form of the command clears the existing pat-
	<pattern>	tern and disables the service. Use '!' for flash in a
		service pattern.

FXS supplementary services description 413