Patton electronic SmartNode 4110 Series manual Debug dialer functionality

SmartWare Software Configuration Guide 30 • PPP configuration

Debug dialer functionality

The following commands show how to display information and events of a PPP dialer.

Mode: enable

Step	Command	Purpose
1	[name] #show call-control provider	Shows configuration and state information
	<dialer> detail <detail>	about a certain dialer instance.
Mode: enable
Step	Command	Purpose
1	[name] #debug dialer detail <detail>	Enables logging of dialer events and state
		changes.
2	[name] #debug ppp <type>	Enables logging of PPP protocol events. See
		“Debugging PPP” on page 325 for further
		information.

Example – Dial-on demand feature

The following example shows a configuration snippet to configure a backup-interface that uses the dial-on demand feature to establish a backup-connection to the remote network. The remote network can be reached either over the dial-in infrastructure of provider 1 or provider 2. Both need different credentials.

context ip

interface IF_PRIMARY

ipaddress 10.1.1.2 255.255.255.0 check-connectivity ping 10.1.1.1

interface IF_SECONDARY ipaddress unnumbered point-to-point

dial-up monitor interface IF_PRIMARY

route 0.0.0.0 0.0.0.0 10.1.1.1 0 route 0.0.0.0 0.0.0.0 IF_SECONDARY 1

subscriber ppp SUB_PROVIDER1 dial out authentication chap pap

identification outbound MY_NAME password MY_PASSWORD bind interface IF_SECONDARY

subscriber ppp SUB_PROVIDER2 dial out authentication pap

identification outbound USER password PWD bind interface IF_SECONDARY

context cs

PPP Dial-up over ISDN 336