Patton electronic SmartNode 4110 Series manual Protocol Error

SmartWare Software Configuration Guide 40 • Call router configuration

Table 21. Hunt group drop causes (Continued)

		Default Behavior
Class	Cause	of the Hunt	Description
		Group Service
Invalid Message	call-identity-in-use	Drop original call	This cause indicates that the network has
(Cont.)			received a call suspends request. The call
			suspend request contained a call identity
			which is already in use for a suspended
			call within the domain of interfaces over
			which the call might be resumed.
	no-call-suspended	Drop original call	The network receives a call resume request
			when there is not a suspended call pend-
			ing. This can be a transient error that will
			be resolved by successive call retries.
	call-has-been-cleared	Drop original call	The network receives a call resume
			request. This call resume request contains
			a call identity that once indicated a sus-
			pended call. However, the suspended call
			was cleared either by time-out or by the
			remote user.
	incompatible-destination	Drop original call	Indicates that an attempt is made to con-
			nect incompatible equipment.
	invalid-transit-network	Drop original call	This cause indicates that a transit network
			identification of an incorrect format was
			received.
	invalid-message	Drop original call	Received an invalid message with no stan-
			dard cause.
Protocol Error	mandatory-ie-missing	Drop original call	The receiving equipment receives a
			message that does not include one of the
			mandatory information elements. This
			cause indicates that the equipment
			sending this cause has received a
			message that is missing a call property
			that must be present in the message before
			that message can be processed.
	message-type-not-imple-	Drop original call	The receiving equipment receives an
	mented		unrecognized message, because the mes-
			sage type is invalid or the message type is
			valid but not supported.
	message-type-not-state-	Drop original call	The remote equipment receives an invalid
	compatible		message with no standard cause. This
			cause indicates that the equipment send-
			ing this cause has received a message
			such that the procedures do not indicate
			that this is a permissible message to
			receive while in the current call state.

Call router configuration task list 504