Patton electronic SmartNode 4110 Series manual Using an alternate SIP profile Optional

SmartWare Software Configuration Guide39 • SIP interface configuration

Mode: Interface SIP

Step	Command	Purpose
1	[node](if-sip)[if-name]#use profile voip	Defines an alternate VoIP profile to be used
	profile-name	for this SIP interface.
		Default: default

Using an alternate SIP profile (Optional)

The SIP profile contains a cause and reason mapping from SIP notation to the call control notation and vice versa. The predefined default profile exists persistently in the system and it is preconfigured with proper default mappings. It will always be taken if no other profile has been specified. This command allows the user to spec- ify an alternate SIP profile to use for all calls routed over this interface. For details about SIP profile configura- tion see Chapter 49, “SIP profile configuration” on page 601.

When a profile has been specified on the interface, it is possible to provide a special one for specific identities or group of identities. It can be configured in location service identities for call inbound and call outbound. See Chapter 51, “Location Service” on page 607 for details about identities and SIP profile configurations. The identity lookup to find a possible configured SIP profile will always be applied to the remote SIP URI. For out- going calls, the SIP Request-URI will be taken. For incoming calls, the SIP From-URI will be taken.

Mode: Interface SIP

Step	Command	Purpose
1	[node](if-sip)[if-name]#use profile sip pro-	Defines an alternate SIP profile to be used for
	file-name	this SIP interface.
		Default: default

Using an alternate Tone-Set profile (Optional)

A Tone-Set profile contains a mapping of call-progress tones to defined tone sequences. The predefined default profile exists persistently in the system and it is preconfigured with the Swiss standard call-progress tone map- ping. It will always be taken if no other profile has been specified. This command allows the user to specify an alternate Tone-Set profile to be use for all calls routed over this interface. For details about Tone-Set profile configuration see Chapter 42, “Tone configuration” on page 529.

When a profile has been specified on the interface, it is possible to provide a special one for specific identities or group of identities. It can be configured in location service identities for call inbound and call outbound. See Chapter 51, “Location Service” on page 607 for details about identites and Tone-Set profile configurations.

The identity lookup to find a possible configured Tone-Set profile will always be applied to the remote SIP URI. For outgoing calls, the SIP Request-URI will be taken. For incoming calls, the SIP From-URI will be taken.

SIP interface configuration task list 445