Patton electronic SmartNode 4110 Series Example Disabling the Sntp client root delay compensation

SmartWare Software Configuration Guide 26 • SNTP client configuration

Example: Disabling the SNTP client root delay compensation

node(cfg)#no sntp-client root-delay-compensation

Showing SNTP client related information

During set-up and operation of the SNTP client, displaying the information and status of the SNTP client is very useful.

This procedure describes how to display information and status of the SNTP client

Mode: Configure

Step Command Purpose

1node(cfg)#show sntp-clientDisplays information and status of the SNTP client

Example: Showing SNTP client related information

node(cfg)#show sntp-client

-------------------------------------------

SNTP client	enabled
Operating mode	unicast
Local port	123
Primary server	172.16.1.10:123 v4
Secondary server	128.138.140.44:123 v4
Anycast address	224.0.1.1:123
Poll interval	30sec
Local clock offset	disabled
GMT offset	+2:00:00

-------------------------------------------

Debugging SNTP client operation

During setup and operation, debugging the behavior of the SNTP client is very useful.

Note The debug sntp client is only available in superuser mode.

This procedure describes how to enable or disable debugging

Mode: Configure

Step Command Purpose

1node(cfg)#debug sntp client Enables and disables SNTP debug monitor. Using the no com- mand syntax disables this feature.

SNTP client configuration task list 289