Patton electronic SmartNode 4110 Series manual Name routing table, IP address routing table

SmartWare Software Configuration Guide 40 • Call router configuration

The call router can route calls according to the following numbering plans. These values beside default can be used for the key parameter to create a routing table entry:

•unknown—Unknown numbering plan. This is the default value for calls that arrive through an interface that does not support the numbering plan property.

•isdn-telephony—ISDN/Telephony numbering plan according to CCITT Recommendation E.164/E.163).

•data—Data numbering plan according to CCITT Recommendation X.121.

•telex—Telex numbering plan according to CCITT Recommendation F.69.

•national-standard—Numbering plan according to a national standard.

•private—Any private numbering plan.

Example: Calling numbering-plan routing table

The following example shows how to create a routing table with name NP that routes calls based on the calling part numbering plan. Calls with calling party numbers formed according to the ISDN/Telephony numbering plan are routed to the next table TAB-INCOMING-ISDN, calls with calling party numbers formed according to the data numbering plan to the next table TAB-INCOMING-DATAand all other calls to the next table

TAB-INCOMING-UNKNOWN.

node(cfg)#context cs node(ctx-cs)[switch]#routing-table calling-numbering-plan NP

node(rt-tab)[NP]#route isdn-telephony dest-table TAB-INCOMING-ISDN node(rt-tab)[NP]#route data dest-table TAB-INCOMING-DATA node(rt-tab)[NP]#route default dest-table TAB-INCOMING-UNKNOWN

Name routing table

The calling display name or called display name (calling-name or called-name) table is used to route calls based on the human-readable name of the calling or called party. The key you specify in a routing table entry must be identical to the display name of the calling or called party for the entry to match.

Note Incoming SIP calls use this call property to store the display name part of the

SIP URI. Other interfaces set the display name to the empty string.

Example: Calling display name routing table

This example routes calls based on the display name part of the From-URI of an incoming SIP call.

node(cfg)#context cs node(ctx-cs)[switch]#routing-table calling-name name node(rt-tab)[name]#route “John Smith” dest-table TAB-FROM-JOHN node(rt-tab)[name]#route Administrator dest-table TAB-FROM-ADMIN node(rt-tab)[name]#route default dest-table TAB-FROM-UNKNOWN

IP address routing table

The calling party IP address (calling-ip) table is used to route calls based on the signaling IP address of the orig- inating VoIP peer, e.g. the IP address of the originating H.323 peer terminal. The called party IP address (called-ip) table is used to route calls based on the called IP address property. The called IP address of incoming calls is set to 0.0.0.0 unless modified by a previous mapping table in the routing path. Thus the called IP address table is of limited use only.

Call router configuration task list 474