Patton electronic SmartNode 4110 Series manual Nodeif-isdn#caller-name ignore, Absence, By default

SmartWare Software Configuration Guide34 • ISDN interface configuration

Step	Command	Purpose
3	node(if-isdn)#caller-name ignore-	(optional) If no name is present in an incoming
	absence 1000	ISDN call and if the incoming SETUP message con-
		tains the NameInformationFollowing indication,
		we forward the call to the routing destination any-
		way after 1000ms (500ms after faking the ALERT-
		ING message in this example).
		This step is optional. When not configured, the call
		is forwarded after 4s by default.
		You can disable forwarding a call without a name
		by using the “no” form of the command.
		Note: The specified timeout is measured starting
		at the reception of the SETUP message, not when
		the early-alerting timeout elapses.

The following example enables and configures the caller-name feature on a T1 ISDN interface for outgoing calls. It enables the transmission of the NameInformationFollowing indication (encapsulated into sent SETUP message) when no name is present from the originating network:

Mode: context cs / interface isdn

Step	Command	Purpose
1	node(if-isdn)#caller-name	Enables transmission of the caller-name.
2	node(if-isdn)#caller-name send-informa-	If no name has been received from the originating
	tion-following	network a NameInformationFollowing indication is
		send encapsulated into the SETUP message for the
		outgoing ISDN call. This feature is disabled
		by default.

ISDN interface configuration task list 403