Patton electronic SmartNode 4110 Series manual Registration inbound face, Inbound

SmartWare Software Configuration Guide 51 • Location Service

Registration inbound face

The registration inbound face is used when you want to allow external user agents to register, so that you can route calls to the registered contacts.

Mode: Identity

	Step	Command	Purpose
1	[node](identity)[name]# [no] registration	Adds a new face to the identity. The no form of the
		inbound	command removes an existing face with all content
			in it.
Mode: Registration inbound
	Step	Command	Purpose
	1	[node](regin)# [no] lifetime [default <sec-	Configures the range of the expiration time
		onds>] [min <seconds>] [max <seconds>]	accepted for inbound registration. If there is a time
			requested which is out of the range the time is set
			to a value which fits the range. If there is no time
			requested it is set to the default lifetime.
Mode: Registration inbound
	Step	Command	Purpose
	1	[node](regin)# [no] contact <host> [<port>]	Adds a contact to the registration inbound face.
		<context cs> <interface sip> [priority <prom-	The interface and context parameter defines where
		ille>	the sip-location-service routes a call destined to
			that contact. The higher priority a contact has the
			sooner a contact is chosen. The default priority is
			1000 which is also the maximum priority. The no
			form of the command removes a contact.

Location Service configuration task list 615