Patton electronic SmartNode 4110 Series Enabling a Frame Relay PVC, Disabling a Frame Relay PVC

SmartWare Software Configuration Guide 15 • Frame Relay configuration

Enabling a Frame Relay PVC

After binding Framerelay PVC to an ip interface it must be enabled for packet processing. This procedure acti- vates the PVC by opening the bound ip interface.

This procedure describes how to enable Framerelay PVC for packet processing

Mode: PVC

Step	Command	Purpose
1	node(pvc)[dlci]#no shutdown	Enables the Frame Relay PVC

Example: Disabling a Frame Relay PVC

The following example enables Frame Relay PVC with the DLCI 1 on the serial interface on slot 0 and port 0.

node(cfg)#port serial 0 0 node(prt-ser)[0/0]#framerelay node(frm-rel)[0/0]#pvc 1 node(pvc)[1]#no shutdown

Check the PVC 1 status using show running-configand verify that the entry no shutdown occurs in the con- figuration part responsible for this PVC.

node(pvc)[1]#show running-config
Running configuration:
#----------------------------------------------------------------	#
#	#
…
pvc 1
encapsulation rfc1490
bind interface wan router
no shutdown

Disabling a Frame Relay PVC

Frame Relay PVCs can be disabled whenever it is necessary. Be aware that disabling a specific PVC also disables the related serial interface and vice versa.

This procedure describes how to disable the Frame Relay PVC DLCI on the serial interface.

Mode: PVC

Step	Command	Purpose
1	node(pvc)[dlci]#shutdown	Disables the Frame Relay PVC DLCI.

Example: Disabling a Frame Relay PVC

The following example disables Frame Relay PVC 1 on the serial interface on slot 0 and port 0.

node(cfg)#port serial 0 0 node(prt-ser)[0/0]#framerelay node(frm-rel)[0/0]#pvc 1

Frame Relay configuration task list 184