Patton electronic SmartNode 4110 Series manual SmartNode in an Enterprise network

SmartWare Software Configuration Guide			31 • CS context overview
02:14:30	CR	> Updating tables in 3 seconds...
02:14:33	CR	> [switch] Reloading tables now
02:14:33	CR	> [switch] Flushing all tables
02:14:33	CR	> [switch] Loading table 'TAB-ISDN-SERVICE'
02:14:33	CR	> [switch] Loading table 'TAB-DEST-A'
02:14:33	CR	> [switch] Loading table 'CAC-APPLE'
02:14:33	CR	> [switch] Loading table 'CAC-ORANGE'
02:14:33	CR	> [switch] Loading table 'CLI-MELON'
02:14:33	CR	> [switch] Loading table 'MAP-CAC-APPLE'
02:14:33	CR	> [switch] Loading table 'MAP-CAC-ORANGE'
02:14:33	CR	> [switch] Loading table 'MAP-CLI-MELON'
02:14:33	CR	> [switch] Loading table 'IF-LOCAL-BA-precall-service'
02:14:33	CR	> [switch] Loading table 'IF-PBX-A-precall-service'
02:14:33	CR	> [switch] Loading table 'IF-NODE-B-precall-service'
02:14:33	CR	> [switch] Loading table 'IF-NODE-C-precall-service'

node(ctx-cs)[switch]#

Example: Configure SmartNode in an Enterprise Network

Situation: Figure 50 shows an enterprise network with a SmartNode configured with a BRI port. A PBX, a LAN, the PSTN, and the company network are connected. The VoIP protocol used is H.323. There is no gate- keeper, so direct call signaling is used. The voice codec used is G.723, so the DTMF relay is enabled. Because no special dial tones have to be specified, the default tone-set profile is used.

	clock distribution
	PSTN
	Office C
Office A	PBX
	147.86.130.11

	User	User
Company	2/3	2/2	Net
		Node	2/1
Backbone	147.86.130.1		Net
Office B			2/0

147.86.130.24

Figure 50. SmartNode in an Enterprise network

Call routing is specified as follows:

•Calls from office C with number 1xx to office A with a fallback to PSTN

•Calls from office C with number 2xx to office B with a fallback to PSTN

•All other calls from office C to PSTN

Activating CS context configuration 351