Patton electronic SmartNode 4110 Series manual Traceroute, Example Debug ARP output

SmartWare Software Configuration Guide10 • IP interface configuration

Mode: Either operator or administrator execution

Step	Command	Purpose
1	node(cfg)# [no] debug arp	Enables or disables the ARP debug monitor.
2	node(cfg)# show arp	Summarizes the ARP information for each of the Ethernet ports.

Traceroute

This procedure describes how to print the route (list of hops) packets take to the network host.

	Step	Command	Purpose
1	node#traceroute <ip_host>	Prints the route that the packets take to the network host.
		[probe-count	Optionally, a traffic-class can be specified in the ‘traceroute’ com-
		<probe_count> ] [timeout	mand. ‘traceroute’ follows the route of the specified traffic-class.
		<seconds> ] [destination-	Default: local-default
		port <port_number> ] [min-
		ttl <min_ttl> ] [max-ttl
		<max_ttl> ] [verbose ]
		[packet-size <packet-size> ]
		[mtu ] [traffic-class <traffic-
		class> ]
Example: Debug ARP output

node(cfg)#debug			arp
node(cfg)#ping 10.9.10.11
Sending 5, 56		bytes, ICMP echo requests to 10.9.10.11:
17:25:40	ARP		> Entry 10.9.10.11: Sending first request
17:25:40	ARP		> Tx ARP Request: Who has 10.9.10.11 tell 10.9.10.1 at
00:A0:BA:00:92:4F
17:25:40	ARP		> Rx ARP Reply: 10.9.10.11 is at 00:50:04:74:94:6C tell 10.9.10.1 at
00:A0:BA:00:92:4F
17:25:40	ARP		> Entry 10.9.10.11: Updated by 00:50:04:74:94:6C
56 bytes from		10.9.10.11: Time 10ms
17:25:40	ARP		> Rx ARP Request: Who has 10.9.10.1 tell 10.9.10.3 at
00:09:5B:53:D2:B0
17:25:40	ARP		> Entry 10.9.10.3: Updated by 00:09:5B:53:D2:B0
17:25:40	ARP		> Tx ARP Reply: 10.9.10.1 is at 00:A0:BA:00:92:4F tell 10.9.10.3 at
00:09:5B:53:D2:B0
% Aborted
Ping statistics for 10.9.10.11:
Packets: Sent 1, Received 1, Lost 0 (0% loss),
RTT:	Minimum 10ms, Maximum 10ms, Average 10ms

IP interface configuration task list 130