Patton electronic SmartNode 4110 Series manual Debugging the clock source, Mode Operator execution

SmartWare Software Configuration Guide 31 • CS context overview

Mode: System

Step	Command	Purpose
1	node(sys)#clock-source hw-type slot port	Add an entry to the end of the list
	node(sys)#clock-sourceindex hw-type slot port	Overwrite and entry at position ‘index’
	node(sys)#clock-source before index hw-type slot port	Insert an entry before position ‘index’
	node(sys)#clock-source after index hw-type slot port	Insert an entry after position ‘index’
	node(sys)#clock-source index up positions	Move entry at ‘index’ number of ‘posi-
		tions’ up
	node(sys)#clock-source index down positions	Move entry at ‘index’ number of ‘posi-
		tions’ down

Debugging the clock source

To control the system behaviour at runtime, there exists a debug command with the options ‘event’ and ‘error’. If the user enables the ‘event’ command, he can follow the system’s Clock Source Hunting algorithm, the out- put informs about the occurrence of a clock source change. In addition exists a ‘show’ command that prints the clock source configuration and marks the ports that are synchronized. Further, the port that has been chosen by the system as the current clock source will also be displayed.

Mode: Operator execution

Step	Command	Purpose
1	node#[no] debug system-clock {event error}	Enables/Disables the system clock moni-
		tor
Mode: Operator execution
Step	Command	Purpose
1	node#show system-clock	Print system clock information

node#show system-clock

Current clock source

====================

t1 0 2 0

Registered clock sources

========================

Name				Sync
e1	0	1 0
t1	0 2 0			X
bri 0 3 0
bri 0 3			1
bri 0 3			2
bri 0 3			3
internal				X

Configuring general CS settings 344