Patton electronic SmartNode 4110 Series Configuring ringback tone on Isdn user-side interfaces

SmartWare Software Configuration Guide 34 • ISDN interface configuration

Example: Configure an alternate PSTN profile

The following example shows how to replace the PSTN profile default of the ISDN interface with the PSTN profile myprofile.

node>enable

node#configure node(cfg)#context cs

node(ctx-cs)[switch]#interface isdn myIsdnIf node(if-isdn)[myIsdnIf]#use profile pstn myprofile

Configuring ringback tone on ISDN user-side interfaces

If a ring-back tone needs to be played towards the PSTN from an ISDN user-side interface, this can be forced using the following command.

Mode: interface isdn <if-name>

Step

Command

Purpose

1[name] (pf-isdn)[if-name]# [no] user-side- ringback-tone

Enables ringback tone to be played on ISDN user- side interfaces. Default: disabled.

Configuring call waiting (optional)

The term “call waiting” is used as follows in this context: If the port bound to this interface is configured to be network side, and both ISDN B-Channels are engaged with calls, and there is a new outgoing call over this interface, the interface can

a)Signal the new call to all connected terminals, although both B-Channels are in use. One terminal can then put its current call on hold to accept the new one (putting the call on hold frees its B-Channel).

b)Not signal the new call, because there is no B-Channel available. This is the desired behavior particularly if the bound port is part of a hunt-group, and no user terminals are connected.

Default behavior is a), using the command below in the inverted form, behavior b) is selected.

Procedure: To configure call waiting

Mode: Interface ISDN

Step	Command	Purpose
1	node(if-isdn)[if-name]#[no] call-waiting	Enable/disable call waiting feature as described
		above (default: enabled)

Disabling call-waiting on ISDN DSS1 network interfaces

This procedure disables support for call-waiting on an ISDN DSS1 network interface.

Mode: interface isdn <if-name>

Step	Command	Purpose
1	[name] (if-isdn)[if-name]# no call-waiting	Disable call-waiting.

ISDN interface configuration task list 393