Patton electronic SmartNode 4110 Series manual Configuration Example

SmartWare Software Configuration Guide40 • Call router configuration

Mode: Context CS

Step	Command	Purpose
1	[name] (ctx-cs)[switch]#[no] ser-	Enters the bridge service configuration mode / deletes a
	vice bridge BRIDGE1	bridge service.
2	[name] (svc-bridg)[BRIDGE1]#port	Creates a port on the service that can accept or spawn calls
	DIALER	(the max number of ports is currently limited to two)
3	[name] (port)[DIALER]# dial persis-	Configures the port to actively dial the called-party “123” to
	tent 123 dest-interface REMOTE	the destination REMOTE. This connection is kept open until
		the service is shut down, or a “no dial” command is issued. If
		the remote side terminates the connection, the port tries to
		reconnect. As soon as the connection is established, the call
		is connected to all other calls present on the service.
4	[name] (svc-bridg)[BRIDGE1]#port	Creates a port on the service that can accept or spawn calls
	LISTENER	(the max number of ports is currently limited to two)
5	[name] (port)[DIALER]# no dial	Without entering a “dial” command, or by specifying “no
		dial”, this port does not dial, but listen for incoming calls. If a
		call comes in, it is automatically connected to all other calls
		present on the service.

Configuration Example:

context cs switch

routing-table called-e164 DISPATCH route 1 dest-service BRIDGE1.dialer

…

service bridge BRIDGE1 port listener

mode listening no shutdown

port dialer

mode dial-persistent 1 dest-interface REMOTE no shutdown

interface h323 REMOTE bind gateway h323

route call dest-table DISPATCH remote 172.16.32.37

interface fxs PHONE1

route call dest-service BRIDGE1.listener

Configuring the service second-dialtone

If a call is routed into the service second-dialtone, the service establishes the call and plays a dial tone to the caller.When a call is entering the service it is first routed to the configured destination. In case the call cannot be placed, the service plays the second dial-tone or the configured announcement to the caller until the caller enters the first DTMF digit.

Call router configuration task list 513