Patton electronic SmartNode 4110 Series manual Deleting call services

SmartWare Software Configuration Guide 40 • Call router configuration

Caveat: For calls from the IP side, the service only works if the G711.alaw codec is chosen. On the SmartNode 4960 the service is available for all configurable codecs.

Mode: Context CS

Step	Command	Purpose
1	node(ctx-cs)[switch]#service second-	Enters the service second-dialtone mode.
	dialtone name
2	node(svc-2dt)[name]#route call dest-	Defines the call destination. If the call cannot be placed the
	interfacedest-servicedest-table	second-dialtone is played.
	name
3	node(svc-2dt)[name]#route	Instead of playing a dialtone locally, the service sets up a call
	announcement dest-inter-	to the configured message provider.
	facedest-servicedest-table
	name
4	node(svc-2dt)[name]#use profile	Apply to use a alternative tone-set profile. If not configured
	tone-set name	the profile tone-set default will be used.

Deleting call services

To remove individual call services you can use the no form of the service command.

Procedure: To delete a call service

Mode: Context CS

Step

1

Command	Purpose
node(ctx-cs)[switch]#no service service-	Delete the service service-name.
name	Note: You do not have to enter the type of the service when
	just deleting it. The type must only be specified when creating
	a service.

Example: Remove an entire mapping table

node(cfg)#context cs node(ctx-cs)[switch]#no service HUNT-BRI

Activate the call router configuration

Prior to activate the call router configuration you can show the whole context CS configuration and the entire call routing tables.

The call router configuration is activated as soon as the CS context comes out of shutdown (e.g. at boot time or by manually entering command no shutdown). You can modify the configuration at runtime; changes will be active after 3 seconds. SmartWare offers a number of possibilities to monitor and debug the CS context and call router configurations. For more information refer to chapter 52, “VoIP debugging” on page 624.

Note It is not necessary to shutdown the CS context prior to making any configu- ration changes.

Call router configuration task list 514