Patton electronic SmartNode 4110 Series Nodeq931slot/port#signalling-rule, Etsi, Pss1old, Range

SmartWare Software Configuration Guide19 • ISDN configuration

Step Command Purpose

2	node(q931)[slot/port]#signalling-rule	Specify channel numbering (Default: etsi)
	etsi	Some older Q-SIG variants make use of a
	or
		channel numbering scheme that differs from
	node(q931)[slot/port]#signalling-rule	the standard ETSI method. In most cases the
	pss1old	ETSI numbering applies. Unless the connected
	or	ISDN devices and configured protocols
	node(q931)[slot/port]#no signalling-rule	require a different scheme, make sure the
		numbering is set to ETSI.
3	node(q931)[slot/port]#uni-side net	Specify the UNI side of the interface.
	or	If not defined on layer2 (q921 mode) this set-
	node(q931)[slot/port]#uni-side user	ting also specifies the UNI side setting for
		layer2.
		The layer 2 settings also apply to Q.SIG
		(PSS1) interfaces.
		Make sure that the device connected to a
		SmartNode ISDN port is operating the oppo-
		site side of the configured uni-side.
4	node(q931)[slot/port]#max-calls number-	Limits the total number of concurrent calls
	of-calls	on the port.
	or	The no form of the command restores the
	node(q931)[slot/port]#no max-calls	default settings.
		Note if the channel-range and
		max-calls command are
		used simultaneously, the
		lower number of chan-
		nels is the limiting
		parameter.
5	node(prt-pstn)[slot/port]#channel-range	Specify B-channel range to be used on a PRI
	min max	port (Default: E1: 0-31, T1: 0-23)
	or	Limits the time-slots to be used for calls to the
	node(prt-pstn)[slot/port]#no channel-	range between min and max. This is in some
	range	cases required for interoperability with ISDN
		services that impose the same limitations.
		Call slots outside the defined range are
		rejected (busy line). If no range is defined
		(Default) all 30 (T1: 23) time-slots are avail-
		able for use.
		The no form of the command restores the
		default settings.

ISDN configuration task list 221