Patton electronic SmartNode 4110 Series Configuring the destination of the call, FXO Mute dialing

SmartWare Software Configuration Guide 36 • FXO interface configuration

Configuring the destination of the call

The last command in configuring the FXO Interface is the route command. This command configures the call router. You can configure the routing-destination for call setup and for service activation. For complete details, see chapter 40, “Call router configuration” on page 456.

Mode: Interface FXO

Step	Prompt, command & response	Purpose
1	node>	Basic prompt in Operator Exec mode
2	node>enable	Enters Administration execution mode
	node#	Response: The prompt in administra-
		tion execution mode is the #
3	node#configure	Enters the Configure configuration
		mode
	node(cfg)#	Response: The prompt in the Configure
		configuration mode is (cfg)#
4	node(cfg)#context cs	Enters the Context CS configure mode
	node(ctx-cs)[switch]#	Response: The prompt in the Context
		CS configuration mode is (ctx-
		cs)[switch]#
5	node(ctx-cs)[switch]#interface fxo if-name	Enter the Interface FXO configuration
		mode
	node(if-fxo)[if-name]#	Response: The prompt in the Interface
		FXO configuration mode is (if-fxo)
		[if-name]#
6	node(if-fxo)[if-name]#[no] route {call {dest-interface	Use this command to route a call (dest-
	interface-name dest-service table-name dest-table	interface) directly to an interface speci-
	service-name} precall {dest-interface interface-name	fied with the interface-nameparame-
	dest-service table-name dest-table service-name}	ter, (dest-table) to the call router using
		the table-nametable as the first routing
		table, or (dest-table) directly to a ser-
		vice specified with the service-name
		parameter.

FXO Mute dialing

A new command has been added. With this command, the FXO interface can mute its receive path during dialtone detection and DTMF digits sending. This to avoid unwanted noises on the calling side (for calls going out of the device through FXO).

Mode: interface fxo

Step Command Purpose

1[name] (if-fxo)# [no] mute-dialingEnables or disables mute of receive path during dialtone detection and dialing. Default: Disabled.

FXO interface configuration task list 424