Patton electronic SmartNode 4110 Series manual AOC-D Support for H.323

SmartWare Software Configuration Guide 38 • H.323 interface configuration

node(cfg)#context cs node(ctx-cs)[switch]#interface h323 MyH323If node(if-h323)[MyH323If]#no status-inquiry

Procedure: To change the default status inquiry interval

Mode: Interface H.323

Step

1

Command	Purpose
node(if-h323)[if-name]#status-inquiry	Changes the status inquiry interval on the
timeout seconds	interface to the specified number of seconds

Example: Disable status inquiries

The following example

the status inquiry interval for the H.323 interface MyH323If to 120 seconds.

node>enable

node#configure node(cfg)#context cs

node(ctx-cs)[switch]#interface h323 MyH323If node(if-h323)[MyH323If]#status-inquiry timeout 120

AOC-D Support for H.323

The H.323 gateway is able to accept and send Advice of Charge during the call (AOC-D) messages according to the ITU-T standard Q.956. Facility Information Elements (IEs) in the Q.931 portion of the protocol are used to transport AOC-D PDUs. (Refer to “Chapter 28: ISDN interface configuration”, section “ISDN Advice of Charge support.”)

You can enable/disable reception and transmission of AOC-D messages separately on each H.323 interface.

When reception is enabled, AOC-D messages received in incoming H.323 FACILITY messages are forwarded to the ISDN side of the call. In addition to the H.323 interface, AOC support must also be enabled on the ISDN interface (see ISDN Advice Of Charge support section of Chapter 28 ISDN interface configuration of the Software Configuration Guide).

When transmission is enabled, AOC-D messages received from the ISDN side of the call are sent as H.323 FACILITY to the remote terminal or gatekeeper.

The following commands can be used to change the AOC-D over H.323 tunneling behavior on an H.323 interface:

H.323 interface configuration task list 439