Patton electronic SmartNode 4110 Series Configuring the Message Waiting Indication feature for FXS

SmartWare Software Configuration Guide 35 • FXS interface configuration

Configuring the Message Waiting Indication feature for FXS

Note Message Waiting Indication is programmed in two sections of SmartWare, the FXS interface and the SIP Location service. The information below refers to information for configuring the Message Waiting Indication feature for FXS. For information on configuring the Message Waiting Indication feature for SIP, see “Configuring the Message Waiting Indication feature for SIP” on page 619.

FXS interface configuration mode allows a selection of the way in which notifications about new voice mes- sages are performed. Supported modes are:

1.Stuttered dial tone (if there is a new message/messages in users voice mailbox, for 3 seconds after taking the phone off-hook the dial-tone will “stutter”, producing short delays between the dial-tone cadence)

2.Visual Message Waiting Indication utilizing frequency shift keying signaling. Visual MWI-enabled FXS phones have a LED on the case to represent a new voice message. The led will blink (or will simply light up) when a new message arrives to the voice mailbox.

3.Both Stuttered dial tone from p.1 and Visual Message Waiting Indication from p.2.

Configuration

You can enable both stutter dial tone and visual message waiting indication at the same time issuing both mes- sage-waiting-indicationcommands independently.

Step Command Purpose

1[node](if-fxs)[name]#[no]message-wait-Enables/Disables Message Waiting Indication

	ing-indication stutter-dial-tone	through Stuttered Dial Tone
Step	Command	Purpose

1[node](if-fxs)[name]#[no]message-wait-Enables Visual Message Waiting Indication through

ing-indication frequency-shift-keying frequency shift keying signaling

FXS interface configuration task list 408