Patton electronic SmartNode 4110 Series manual Enable tone-set profile

SmartWare Software Configuration Guide 42 • Tone configuration

Step

2

3

4

Command	Purpose
node(pf-tones)[name]#map	Map a call-progress-tone profile to an internal
call_progress_tone	tone. An internal tone represents the call event
{	for which a tone indication can be provided.
busy-tone	Use the CLI help to get a list of all available
	events.
confirmation-tone
congestion-tone
dial-tone
hold-tone
release-tone
ringback-tone
special-dial-tone
special-information-tone
waiting-tone
} call-progress-tone
	Repeat step 2 for all internal tone events.
[name](pf-tones)[name]#[dtmf-signal-level	Defines the output level of DTMF signals gen-
	erated lcoally. This applies also to relayed
	DTMF signals.

Example: Configuring a tone-set

The following example shows how to configure a tone-set profile for UK.

node(cfg)#profile tone-set UK node(pf-tones)[UK]#map call_progress_tone dialtone dialUK

node(pf-tones)[UK]#map call_progress_tone alertingtone ringUK node(pf-tones)[UK]#map call_progress_tone busytone busyUK

Enable tone-set profile

A call on the SmartNode always has two signaling protocol endpoints. At the moment it is only possible to play locally generated tones on PSTN endpoints (ISDN, FXS) and not on IP based signaling endpoints (H.323, SIP). Dependent on the configuration several combinations of signaling protocol endpoints are possi- ble (ISDN–ISDN, H.323-ISDN, FXS-SIP etc.). The SmartNode will always generate the tones locally and play it on the PSTN line as long as the other endpoint doesn’t notifies availability of inband information and the PSTN endpoint is NOT of type ISDN-USER or FXO. If availability of inband information will be noti- fied by one endpoint, the bearer channel already contains the necessary tone information and must not be gen- erated locally.

If the user has not specified a tone-set profile, the default tone-set will be taken to generate the local inband information. For enabling a user defined tone-set profile on a specific interface proceed as follows.

Procedure: To assign a tone-set profile to a PSTN interface

Tone configuration task list 533