Power and Setup Issues

This section provides tips for resolving problems concerning power to the printer and host or concerning printer setup.

My printer has no power.

Make sure the power cord is plugged into the printer and the power source. See “Connecting the Power Cord” in chapter 2.

Make sure the printer is turned on. See “Turning the Printer On” in chapter 2.

Make sure the power source is grounded, working, and rated for 100 V, 15 A.

The printer has power but no start-up page prints.

Make sure the start-up page feature is enabled. See “Start-up Page” in chapter 6.

Check the front panel window for a status message. See “Status Messages” in this chapter.

Make sure the toner cartridge is installed properly. See “Toner Cartridge” in chapter 2.

Make sure there is paper in the selected tray. If you are using a paper cassette, make sure it is installed properly. See “Paper Cassette” and “Multipurpose Feeder” in chapter 2.

My printer does not respond properly to my Macintosh using a LocalTalk connection.

Make sure all cables are connected and seated properly. See “Connecting to the LocalTalk Port” in chapter 2.

Make sure both ends of the LocalTalk network have terminating resistors installed. See “Connecting to the LocalTalk Port” in chapter 2.

11-6 Troubleshooting ____________________________________

Page 288
Image 288
Xante 3 Series warranty Power and Setup Issues, My printer has no power