Network Installation | ColorQube™ 9201/9202/9203 |
8.Ensure the [Enabled] box is checked to enable Raw TCP/IP Printing.
9.Leave the [TCP Port Number] set to 9100 for Port 1. If two additional ports are available, click [Default All] to see if they set to 9101 and 9102 respectively (emulating HP JetDirect EX Plus 3).
10.Leave the [Bidirectional] and [Maximum Connections] settings at their default values.
11.Set the [End of Job Timeout] to the number of seconds to wait before processing a job without an End Of Job indicator.
12.Leave the [PDL Switching] Enabled box at its default value.
13.Click on the [Apply] button to accept the changes, [Undo] to return the settings to their previous values, or [Default All] to enter printer defaults for all settings (recommended).
14.Click on the [OK] button when you see the window that says “Properties have been successfully modified”.
Note
The settings are not applied until you restart the device.
15.Click on the [Status] tab, select [Description & Alerts] in the directory tree.
16.Click the [Reboot Machine] button and click [OK] to reboot the device. The network controller takes approximately 5 minutes to reboot and network connectivity will be unavailable during this time
Create an IPP Printer (Internet Printing Protocol)
Information Checklist
Before starting the installation procedure, please ensure the following items are available or have been performed:
1.Ensure TCP/IP and HTTP are configured on the device as per Enable TCP/IP and HTTP at the Device on page
2.Ensure that the DNS settings are configured.
Enable Port 9100 as additional support for HTTP (IPP) printing
1.At your Workstation, open the web browser and enter the IP address of the device in the Address bar, and press [Enter].
2.Click on the [Properties] tab.
3.If prompted, enter the Administrator User ID and Password. The default is [admin] and [1111].
4.Click on the [Login] button.
5.Click on the [Connectivity] link.
6.Click on the [Protocols] link.
7.Select [Raw TCP/IP Printing] in the directory tree.
8.Ensure the [Enabled] box is checked to enable Raw TCP/IP Printing.
9.Leave the [TCP Port Number] set to 9100 for Port 1. If two additional ports are available, click [Default All] to see if they set to 9101 and 9102 respectively (emulating HP JetDirect EX Plus 3).
10.Leave the [Bidirectional] and [Maximum Connections] settings at their default values.
11.Set the [End of Job Timeout] to the number of seconds to wait before processing a job without an End Of Job indicator.
12.Leave the [PDL Switching] Enabled box at its default value.
13.Click on the [Apply] button to accept the changes.
System Administrator Guide |
