ColorQube™ 9201/9202/9203 | Device Connection |
How to Add or Change a Static IP Address when there is no DHCP Server Available
At the Device
1.Press the <Log In/Out> button.
2.Enter the Administrator’s User Name [admin], touch [Next], enter the Password [1111], then touch [Enter].
3.Touch the <Machine Status> button.
4.Touch [Tools].
5.Touch [Network Settings].
6.Touch [TCP/IP Settings].
7.Touch [Dynamic Addressing].
8.Touch [Disable] to disable DHCP, and touch [Save].
9.Touch [IP Address/Host Name].
10.Touch [IP Address] and enter a valid IP Address and touch [Save].
11.Touch [Host Name] and enter host name and touch [Save].
12.Touch [Close].
13.Touch [Subnet and Gateway].
14.Touch [IP Gateway] and enter a valid gateway address and touch [Save].
15.Touch [Subnet Mask] and enter a valid subnet mask address and touch [Save].
16.Touch [Close].
17.Touch [TCP/IP Enablement], ensure it is enabled and touch [Save].
18.Touch [Close].
19.Press the <Log In/Out> button.
20.Touch [Logout] to exit the Tools pathway.
Configure Protocols with Internet Services
Internet Services is a series of web pages, hosted on the embedded HTTP server of the device, allowing configuration of services and settings using a web browser.
Refer to the Protocols section of this guide and follow the instructions to configure protocols.
To configure individual protocols only, using your web browser, perform the following steps:
1.At your Workstation, open the web browser and enter the IP address of the device in the Address bar, and press [Enter].
2.Click on the [Properties] tab.
3.If prompted, enter the Administrator User ID and Password. The default is [admin] and [1111].
4.Click on the [Login] button.
5.Click on the [Connectivity] link, then click on the [Protocols] link.
Note
To see IPv6 addressing parameters, if desired, click IP (Internet Protocol) in the list of Protocols, then click on IP (v6).
6.Select your individual protocol of interest from the displayed list and modify settings to your requirements.
System Administrator Guide |
