Network Installation | ColorQube™ 9201/9202/9203 |
• Select [Remote Printer is on a BSD System] and click [OK] to complete form.
9.Click [Yes] at the Configure HP UX Printers Subpanel screen. This screen may be obscured by Add Remote Printer/Plotter form.
10.Select [File: Exit].
11.Select [File: Exit Sam].
12.Type [exit] to exit super user mode.
13.Test the queue created. Type the command [lp
tty Method
Follow the steps below to use the HP System Administrator Manager (SAM) GUI (Graphical User Interface).
Note
Refer to the
1.Open a command window on the desktop. From the command prompt (#), enter the information below. Remember that UNIX commands are
2.Type [su] to become super user
3.Type [sh] to run the Bourne shell.
4.Type [lpshut] to stop the print service.
5.Create the print queue by typing (on the same command line): [lpadmin
Where queuename is the name of the queue being created and hostname is the machine hostname from the /etc/hosts file.
6.Type [lpsched] to start the print service.
7.Type [enable queuename] to enable the queue to print to the machine.
8.Type [accept queuename] to the queue accepting jobs from the
9.Type [exit] to exit the Bourne shell and then [exit] to exit super user mode.
10.Test the queue created. Type the command [lp
11.Verify that the job is printed at the device.
Solaris 2.x
Information Checklist
Before starting the installation procedure, please ensure the following items are available or have been performed:
•Ensure that the correct IP Address is being used for the machine. To verify this, print a Configuration Report from the machine.
At the Device
a.Press the <Machine Status> button on the device.
b.Touch the [Machine Information] tab.
c.Touch [Information Pages].
d.Touch [Configuration Report].
e.Touch [Print], then touch [Close].
System Administrator Guide |
