Lucent Technologies 5 manual Adding/Removing a Line, Planning Guidelines

MERLIN LEGEND Communications System Release 5.0		Issue 1
System Manager’s Guide 555-650-118		June 1997
6 Managing the System
	Adding/Removing a Line	Page 6-56
	Adding/Removing a Line	6

Use this procedure to add a line to or remove a line from the system.

Planning Guidelines 6

If you are adding a new line and need to order a module to connect the line,

cordinate the installation and connection dates to ensure that the new module is installed before the line is connected to the system.

Task List:oAdding/Removing a Line 6

Obtain Form 2c, System Numbering: Line/Trunk Jacks. Check the form to confirm that there is a spare jack.

NOTE:

If you are adding a line but there is no spare jack, you need to add a new module. Contact your Lucent Technologies representative.

Contact your central office (CO) to obtain a new line or to disconnect a line.

If you are adding a line/trunk, call Lucent Technologies 1 800 247-7000 to arrange for a Lucent Technologies technician to connect the line to the system and set it up (charges may apply). If you are removing a line, it is not necessary to make any such arrangements.

NOTE:

A new module must be installed before a line is connected to it.

After the line is connected and set up or is disconnected, open the System Programming menu from the console or a PC with SPM to program it as described in the next task.

Assign the line to or unassign the line from a pool, to/from extensions (if it is a personal line), to/from a calling group, or to/from Remote Access, as appropriate, following the instructions in the “Telephones” section of Chapter 3 in System Programming.

oRevise the appropriate planning form(s).

When you have finished, file the form(s) with the rest of the planning forms.

Programming Instructions 6

See the appropriate procedures in System Programming as noted in the task list above.