Lucent Technologies 5 manual Adding a DLC Operator Position, MLX-20L

MERLIN LEGEND Communications System Release 5.0		Issue 1
System Manager’s Guide 555-650-118		June 1997
6 Managing the System
	Adding a DLC Operator Position	Page 6-57
	Adding a DLC Operator Position	6

Use this procedure to add a DLC operator position to either an MLX or an analog multiline extension module.

To add a QCC operator position, see the next section, ‘Adding‘ a QCC Operator

Position’’ on page 6-60.

Planning Guidelines 6

DLC operator positions can be assigned to the first and fifth extension jacks on any MLX or analog multiline module. The first jack on the first extension module in your system is automatically assigned as the primary operator position.

If your system has Call Management System (CMS), the two CMS connections must be made to analog jacks. Each CMS requires two DLC operator positions on the same analog module to connect the equipment and one position to serve as CMS supervisor.

A maximum of eight DLC operator positions can be assigned. Any combination of operator positions can be assigned as long as there are not more than four QCC operator positions (Hybrid\PBX) and no more than a total of eight operator positions (see Table 6–10).

Table 6–10. Maximum Number of Operator Positions

		Maximum
Position Type	Type of Telephone	Positions
QCC	MLX-20L	4
DLC	MLX-20L	8
	MLX-28D
	BIS-34D, BIS-22, or BIS-22D
	analog multiline telephone
	MERLIN II Display Console

Lines and trunks are assigned on individual buttons.

NOTE:

Because this procedure requires an idle system, you may want to perform it after hours. Also, when you change an extension to or from an operator position, the system returns the port (extension jack) type of that extension to the factory setting. You must reprogram lines and any features for that telephone or console. You may also need to reprogram any attached adjunct equipment and optional features.