Lucent Technologies 5 manual Revising Night Service with Coverage Control

MERLIN LEGEND Communications System Release 5.0			Issue 1
System Manager’s Guide 555-650-118			June 1997
6 Managing the System
Revising Night Service with Coverage Control			Page 6-80
Programming Instructions		6
Console Procedures	To assign a calling group to a Night Service group:
	NightSrvce→GroupAssign→Calling Group→Dial
	ext. no. of Night Service operator→Enter→Dial calling
	group no.→Enter→Exit→Exit
	To assign an extension to a Night Service group:
	NightSrvce→GroupAssign→Extensions→Dial ext.
	no. of Night Service operator→Enter→Dial ext. no. of
	member→Enter→Exit→Exit
	To assign a line to a Night Service group (Release 4.1
	and later systems only):
	NightSrvce→GroupAssign→Lines→Dial ext. no. of
	Night Service operator→		→Dial outside line no.
	(801–880)→	→ ￿→￿
PC Procedures	To assign a calling group to a Night Service group:
	→ →	→Type ext. no. of Night Service
	operator→￿→Type calling group no.→￿→￿→

To assign an extension to a Night Service group:

→ → →Type ext. no. of Night Service

operator→ →Type ext. no. of member→￿→

→

To assign a line to a Night Service group (Release 4.1 and later systems only):

→ → →Type ext. no. of Night Service

￿operator→ ￿→Type outside line no. (801–880)→

→￿→

Revising Night Service with	6
Coverage Control

In Release 4.1 and later systems, system managers can coordinate the status of Coverage VMS Off buttons programmed at extensions with Night Service operation.

With this feature enabled (the factory setting is disabled), the following occurs:

■When Night Service is turned on, all Coverage VMS Off buttons are deactivated; that is, the programmed voice-messaging system calling group takes calls.