Lucent Technologies 5 manual Task List Adding a DLC Operator Position

MERLIN LEGEND Communications System Release 5.0	Issue 1
System Manager’s Guide 555-650-118	June 1997
6 Managing the System
Adding a DLC Operator Position	Page 6-58

The procedure to add an operator position involves several tasks that require decisions, for example, assigning features like calling restrictions, Coverage, calling group, Pickup group, paging group, Night Service, Forced Account Code Entry, and Remote Call Forwarding. If necessary, read about the individual features in the Feature Reference for detailed information.

Yu also need to make decisions about assigning buttons. There are two types of buttons: system-programmed buttons (for example, SA or ICOM buttons) to access an inside or outside line or pool of outside lines, and blank line buttons that can be programmed with system features like Do Not Disturb. ‘Line‘ Buttons on Multiline Telephones’’ on page 3-25 of this guide includes information about buttons; information about individual features is in the Feature Reference.

Before you actually begin performing the items in the task list below, read through the list and make your decisions now about these and other aspects of the new extension rather than having to stop in the middle of the procedure.

Fr additional planning information, see the “Telephones” section in Chapter 3 of System Programming.

Task List: Adding a DLC Operator Position 6

Obtain Form 2a, System Numbering: Extension Jacks, Form 6a, Optional

Operator Features, and one of the following, as appropriate: 5a, Direct-Line

Console (DLC): Analog; or 5b, Direct-Line Console (DLC): Digital.

If necessary, read “Direct-Line Console” in the Feature Reference for

odetailed information about DLC consoles.

Check Form 2a for available operator-position jacks; look for the shaded first and fifth lines on the form.

NOTE:

If there are no available operator-position jacks, contact your Lucent Technologies representative.

Plan changes using the planning guidelines above; record the new values on the form(s).

oOpen the System Programming menu from the console or a PC with SPM.

If your system uses the Set Up Space numbering plan (see Form 2a), single-renumber the extension jack, following the instructions in “Single Renumbering” in the “System Renumbering” section of System Programming, Chapter 3.

NOTE:

This task requires an idle condition: Extension Forced Idle for this extension jack.