Lucent Technologies 5 manual Changing Calling Group Assignments

MERLIN LEGEND Communications System Release 5.0	Issue 1
System Manager’s Guide 555-650-118	June 1997
6 Managing the System
Changing Calling Group Assignments	Page 6-68

For a voice messaging system and auto attendant:

Console Procedure AuxEquip→VMS/AA→TransferRtn→Drop→Dial no. of rings→Enter→TT Duration→Drop→Dial no. of ms→ Enter→TT Interval→Drop→Dial no. of ms→ Enter→Exit→Exit

PC Procedure ￿→￿→￿→!+ 0→Type no. of rings→￿→ !→!+ 0→Type no. of ms→ → →

+ 0→Type no. of ms→￿→￿→￿

For the other auxiliary equipment noted above:

Console Procedure	AuxEquip→MusicOnHold or Ldspkr Pg or
	MaintAlarms→Dial line/trunk no.→Enter→Exit
PC Procedure	→ →Type line/trunk no.→￿→￿

Changing Calling Group Assignments 6

Use this procedure to assign or remove an extension from a calling group.

Planning Guidelines 6

An extension can belong to only one calling group. A QCC cannot be a member of a calling group. A delay announcement device should not be programmed as a calling group member.

A calling group can be a Night Service group member.

The total number of extensions can be divided into a maximum of 32 calling groups. A calling group can include a maximum of 20 extensions, but not all 32 calling groups can have this maximum number.

If a linear hunting pattern is indicated on the back of the system planning form (7d), be sure to assign extensions to the group in the exact order that they are shown on the form. The system searches for an available member in the order in which you assign the extensions to the group.

The Extension Status feature must be set to the calling group or CMS mode before you assign members to the group. For more information, see “Extension Status” in the Feature Reference and in the “System Features” section of Chapter 3, System Programming.

Changing calling group assignments may affect other features; for more information, see the Feature Reference.