Teledyne 9110T instruction manual Table of Contents

Model 9110TH NOx AnalyzerTable of Contents

TABLE OF CONTENTS

Information About the Specific Configuration of Your Model 9110T NOX Analyzer			..............................................................iii
Mounting Options			iv
Pump Mounting Options			iv
Rear	Panel Gas Fittings		iv
Safety Messages			vii
About This Manual			ix
PART I	GENERAL INFORMATION		21
1. Introduction, Features and Options			23
1.1. Overview			23
1.2. Features			23
1.3. Documentation			24
1.4. Options			24
2. Specifications, Approvals, & Compliance			27
2.1. Specifications			27
2.2. EPA Equivalency Designation			28
2.3. Approvals and Certifications			29
2.3.1. Safety			29
2.3.2. EMC			29
2.3.3. Other Type Certifications			29
3. Getting Started		31
3.1. Unpacking the 9110T Analyzer			31
3.1.1. Ventilation Clearance			32
3.2. Instrument Layout			32
3.2.1. Front Panel			33
3.2.2. Rear Panel			37
3.2.3. Internal Chassis Layout			38
3.3. Connections and Setup			41
3.3.1. Electrical Connections			41
3.3.2. Pneumatic Connections			55
3.4. Startup, Functional Checks, and Initial Calibration			74
3.4.1. Start Up			74
3.4.2. Warning Messages			75
3.4.3. Functional Checks			77
3.4.4. Initial Calibration			77
3.4.4.1. Interferents		..........................................................................................................................................................	78
PART II – OPERATING INSTRUCTIONS			85
4. Overview of Operating Modes			87
4.1. Sample Mode			88
4.1.1. Test Functions			88
4.1.2. Warning Messages			91
4.2. Calibration Mode			92
4.3. Setup Mode			92
4.3.1. Password Security			93
4.3.2. Primary Setup Menu			93
4.3.3. Secondary Setup Menu (SETUP MORE)			93
5. Setup Menu		95
5.1. SETUP  CFG: Configuration Information			95
5.2. SETUP ACAL: Automatic Calibration Option			95
5.3. SETUP DAS: Internal Data Acquisition System			95
5.4. SETUP RNGE: Analog Output Reporting Range Configuration			96
5.4.1. 9110T Physical Ranges			96
5.4.2. 9110T Analog Output Reporting Ranges			96
5.4.3. SETUP  RNGE  MODE			98
5.5. SETUP  PASS: Password Protection			106
5.6. SETUP  CLK: Setting the Internal Time-of-Day Clock			108
5.6.1. Setting the Time of Day			108
5.6.2. Adjusting the Internal Clock’s Speed			109
5.7. SETUP  COMM: Communications Ports			110
5.7.1. ID (Machine Identification)			110
5.7.2. INET (Ethernet)			111
5.7.3. COM1[COM2] (Mode, Baude Rate and Test Port)			111
5.8. SETUP  VARS: Variables Setup and Definition			111

Teledyne Analytical Instruments 11