Teledyne 9110T instruction manual USB Port For remote connection

	Model 9110T NOx Analyzer				Introduction
Option		Option	Description/Notes		Reference
		Number
		minute, calibration performed at a tube temperature of 50°C.
Communication Cables			For remote serial, network and Internet communication with the analyzer.
			Type	Description
				Shielded, straight-through DB-9F to DB-25M cable, about	Section 3.3.1.8
		60A	RS-232	1.8 m long. Used to interface with older computers or
				code activated switches with DB-25 serial connectors.
		60B	RS-232	Shielded, straight-through DB-9F to DB-9F cable of about	Section 3.3.1.8
				1.8 m length.
		60C	Ethernet	Patch cable, 2 meters long, used for Internet and LAN	Section 3.3.1.8
				communications.
		60D	USB	Cable for direct connection between instrument (rear	Section 3.3.1.8
				panel USB port) and personal computer.
USB Port			For remote connection
		64A	For connection to personal computer. (Separate option only when		Sections 3.3.1.8
			Option 64B, Analog Input and USB Com Port not elected).		and 6.6
Concentration Alarm Relays			Issues warning when gas concentration exceeds limits set by user.
			Four (4) “dry contact” relays on the rear panel of the instrument. This		Section 3.3.1.7
		61	relay option is different from and in addition to the “Contact Closures”
			that come standard on all TAPI instruments.
RS-232 Multidrop			Enables communications between host computer and up to eight analyzers.
		62	Multidrop card seated on the analyzer’s CPU card.		Section 3.3.1.8
			Each instrument in the multidrop network requres this card and a
			communications cable (Option 60B).
Other Gas Options			Second gas sensor and gas conditioners
		65A	Oxygen (O2) Sensor		Figure 3-6
		86A	Ammonia removal sample conditioner (required for EN Certification)		3.3.2.6, 3.4.4.1
					Figure 3-29,
		86C	External zero air scrubber		Sections 3.3.2.6,
					9.1.2.1, 11.3.7, and
					11.3.7.1, Table 11-1
Special Features			Built in features, software activated
			Maintenance Mode Switch, located inside the instrument, places
			the analyzer in maintenance mode where it can continue sampling,
		N/A	yet ignore calibration, diagnostic, and reset instrument commands.		N/A
			This feature is of particular use for instruments connected to
			Multidrop or Hessen protocol networks.
			Call Customer Service for activation.
			Second Language Switch activates an alternate set of display
		N/A	messages in a language other than the instrument’s default		N/A
			language.
			Call Customer Service for a specially programmed Disk on Module containing
			the second language.
			Dilution Ratio Option allows the user to compensate for diluted
			sample gas, such as in continuous emission monitoring (CEM) where
		N/A	the quality of gas in a smoke stack is being tested and the sampling		Section 5.4.3.5
			method used to remove the gas from the stack dilutes the gas.
			Call Customer Service for activation.

Teledyne Analytical Instruments 26