Teledyne 9110T instruction manual Default Ethernet setting is Dhcp

Model 9110TH NOx Analyzer			Communications Setup and Operation
	Table 6-3. LAN/Ethernet Default Configuration Properties
	PROPERTY	DEFAULT STATE	DESCRIPTION
	DHCP		This displays whether the DHCP is turned ON or OFF. Press
		ON	EDIT and toggle ON for automatic configuration after first
			consulting network administrator.
	INSTRUMENT		This string of four packets of 1 to 3 numbers each (e.g.
	IP ADDRESS		192.168.76.55.) is the address of the analyzer itself.
	GATEWAY IP	0.0.0.0	Can only be edited when DHCP is set to OFF.
			A string of numbers very similar to the Instrument IP address
	ADDRESS		(e.g. 192.168.76.1.) that is the address of the computer used by
			your LAN to access the Internet.
			Can only be edited when DHCP is set to OFF.
			Also a string of four packets of 1 to 3 numbers each (e.g.
		0.0.0.0	255.255.252.0) that identifies the LAN to which the device is
	SUBNET MASK		connected.
			All addressable devices and computers on a LAN must have the
			same subnet mask. Any transmissions sent to devices with
			different subnets are assumed to be outside of the LAN and are
			routed through the gateway computer onto the Internet.
	TCP PORT1	3000	This number defines the terminal control port by which the
			instrument is addressed by terminal emulation software, such as
			Internet or Teledyne API’s APICOM.
		[initially blank]	The name by which your analyzer will appear when addressed
	HOST NAME		from other computers on the LAN or via the Internet. To assign
			or change, see Section 6.5.2.1.
	1 Do not change the setting for this property unless instructed to by TAI’s Customer Service personnel.

6.5.2.CONFIGURING ETHERNET COMMUNICATION USING DYNAMIC HOST CONFIGURATION PROTOCOL (DHCP)

The default Ethernet setting is DHCP.

Teledyne Analytical Instruments 143