Teledyne 9110T instruction manual Using

Model 9110TH NOx Analyzer Getting Started

Figure 3-14: Default Pin Assignments for CPU COMM Port Connector (RS-232).

TAI offers two mating cables, one of which should be applicable for your use.

∙P/N WR000077, a DB-9 female to DB-9 female cable, 6 feet long. Allows connection of the serial ports of most personal computers.

∙P/N WR000024, a DB-9 female to DB-25 male cable. Allows connection to the most common styles of modems (e.g. Hayes-compatible) and code activated switches.

Both cables are configured with straight-through wiring and should require no additional adapters.

Note	Cables that appear to be compatible because of matching connectors
	may incorporate internal wiring that makes the link inoperable. Check
	cables acquired from sources other than TAI for pin assignments before
	using.

To assist in properly connecting the serial ports to either a computer or a modem, there are activity indicators just above the RS-232 port. Once a cable is connected between the analyzer and a computer or modem, both the red and green LEDs should be on.

∙If the lights are not lit, locate the small switch on the rear panel to switch it between DTE and DCE modes.

∙If both LEDs are still not illuminated, ensure that the cable properly constructed.

Received from the factory, the analyzer is set up to emulate an RS-232 DCE device.

Teledyne Analytical Instruments 51