Teledyne 9110T instruction manual Automatic Individual Calibration of the Analog Outputs

Model 9110TH NOx Analyzer	Setup Menu
5.9.3.4. Automatic Group Calibration of the Analog Outputs
IMPORTANT	IMPACT ON READINGS OR DATA

Manual calibration should be used for any analog output set for a 0.1V output range or in cases where the outputs must be closely matched to the characteristics of the recording device. (See Sections 5.9.3.2, 5.9.3.3, and 5.9.3.6).

IMPORTANT	IMPACT ON READINGS OR DATA
	Before performing this procedure, ensure that the AUTO CAL for each
	analog output is enabled. (See Section 5.9.3.3).

To calibrate the outputs as a group with the AOUTS CALIBRATION command, select the ANALOG I/O CONFIGURATION submenu (see Figure 5-5) then press:

5.9.3.5. Automatic Individual Calibration of the Analog Outputs

To use the AUTO CAL feature to initiate an automatic calibration for an individual analog output, select the ANALOG I/O CONFIGURATION submenu (see Figure 5-5) then press:

Teledyne Analytical Instruments 121