Teledyne 9110T Before Calibration, Required EQUIPMENT, SUPPLIES, and Expendables

Model 9110T NOx Analyzer Calibration Procedures

This section describes how to judge the effectiveness of a recently performed calibration. SECTION 9.7 – Gas Flow Calibration

This section describes how to adjust the gas flow calculations made by the CPU based on pressure and flow sensor readings.

Note	Throughout this Section are various diagrams showing pneumatic
	connections between the 9110T and various other pieces of equipment
	such as calibrators and zero air sources.
	These diagrams are only intended to be schematic representations of
	these connections and do not reflect actual physical locations of
	equipment and fitting location or orientation.
	Contact your regional EPA or other appropriate governing agency for
	more detailed recommendations.

9.1. BEFORE CALIBRATION

The calibration procedures in this section assume that the range mode, analog range and units of measure have already been selected for the analyzer. If this has not been done, please do so before continuing (see Section 5.4.3 for instructions).

Note	If any problems occur while performing the following calibration
	procedures, refer to Section 12.1 for troubleshooting tips.

9.1.1. REQUIRED EQUIPMENT, SUPPLIES, AND EXPENDABLES

Calibration of the 9110T NOx Analyzer requires:

∙Zero-air source.

∙Span gas source.

∙Gas lines - all gas line materials should be stainless steel or Teflon-type (PTFE or FEP).

∙High-concentration NO gas transported over long distances may require stainless steel to avoid oxidation of NO due to the possibility of O2 diffusing into the tubing.

∙A recording device such as a strip-chart recorder and/or data logger (optional).

∙For electronic documentation, the internal data acquisition system (DAS) can be used.

Teledyne Analytical Instruments 194