Teledyne 9110T instruction manual Stsystemok=On, Stsystemok = on

Model 9110T NOx Analyzer Setup Menu

5.9.1. SIGNAL I/O

The signal I/O diagnostic mode allows a user to review and change the digital and analog input/output functions of the analyzer. Refer to Appendix A for a complete list of the parameters available for review under this menu.

IMPORTANT	IMPACT ON READINGS OR DATA
	Any changes of signal I/O settings will remain in effect only until the
	signal I/O menu is exited. Exceptions are the ozone generator override
	and the flow sensor calibration, which remain as entered when exiting.

Access the signal I/O test mode from the DIAG Menu (Figure 5-4), then press:

DIAG	SIGNAL I / O
PREV NEXT JUMP	ENTR EXIT

Press NEXT & PREV to move between signal types.

DIAG I / O	0) EXT_ZERO_CAL=OFF
PREV NEXT JUMP		PRNT EXIT
EXAMPLE
DIAG I / O	JUMP TO: 12
1 2		ENTR EXIT

Press JUMP to go directly to a specific

signal

See Appendix A-4 for

a complete list of

available SIGNALS

EXAMPLE:

Enter 12 to Jump to

12) ST_SYSTEM_OK=ON

DIAG I / O	12) ST_SYSTEM_OK = ON			Exit to return
				to the
PREV NEXT JUMP		ON	PRNT EXIT	DIAG menu
	Toggle ON/(OFF) button to		Pressing the PRNT button will send a formatted
			printout to the serial port and can be captured
	change status.		with a computer or other output device.

Teledyne Analytical Instruments 116